You also want to make sure the protection you use is of the right type for the rivet buster you are using.Ī rivet buster can be a very valuable tool, but if you aren’t using it safely, you could certainly be putting your life at risk. Click here for more information. At a minimum, you should be wearing eye protection, a hard hat and ear protection. This is important anytime you are on a construction site and even more important when you are actually using the tool. Finally, ensure that the pressure is right before using the tool.įinally, you will want to be sure that you are wearing proper safety gear when you use an air tool like a rivet buster. Speaking of the hose, make sure it is properly attached and everything is where it is supposed to be. You should also inspect the hose of the rivet buster for holes or weak spots, as this can also be problematic if not taken care of. Even a paving breaker would need to twice as heavy to deliver an equivalent blow. Their long stroke and high impact energy, coupled with the ergonomics of the rivet buster value, make them ideal for extended demolition use. You should be sure that everything looks as if it is in working order and that nothing looks out of place. The TEX rivet busters are tough, powerful tools designed for heavy demolition work. You should also observe and practice using the tool in a safe and controlled manner before using it in the field.īefore you engage in the use of a rivet buster, it is always a good idea to visually inspect it. If you don’t know anything about rivet busters, make sure to educate yourself about the tool by reading up on its use online, or better yet, if you can get your hands on a user manual, read that. If you are not familiar with an air tool, like a rivet buster, you could easily injure yourself or others very seriously. When it comes to using rivet busters in New York City, it is imperative that you learn all you can about the tool. Here are some tips that you should keep in mind when it comes to using rivet busters in New York City: Also known as a pneumatic hammer, or jackhammer, a tool like a rivet buster must be used safely. One sharp tap with a small hammer dispatches the head with nary a scratch on the part.If you work in construction, or sometimes in other fields in the New York City area, you may find yourself using a tool called a rivet buster. Position the chisel at the edge of the factory head with the sharp edge against the part and as close to flat against the part as possible. I finished it off by removing the sharp corners and all but the center 1/4-inch of the edge.īack to the stubborn rivet head. Next the end of the bit was ground to an angle with a sharp edge. One good whack with a hammer and the point was removed. I took an old butterfly wood bit and clamped it in the vise with the point protruding above the jaws. I’ve used chisels before for all sorts of jobs, and this seemed a good fit.
I didn’t want to do damage to the part by forcing the issue, so a new tool was born. Most of the heads snapped off clean by using an old drill bit, but one or two refused to break clean. All went well, first drilling the rivet with a #40 bit, then drilling through the head with #30. Recently I made an error and needed to drill several AN470AD4 rivets in a very confined space. This “rivet buster” chisel was made from an old butterfly wood drill bit.
0 kommentar(er)
